Framing A Support Wall Under Stairs

Veröffentlicht am: 27 Juni 2024
auf dem Kanal: HAUS PLANS ®️
19,508,155
589k

These stairs have a lot of bounce to them, I’m going to frame a support wall in the middle to fix it.
First, I measure and lay off where the wall will go.
Then I cut a pressure treated 2x4 to the width of the stairs- 42”.
I fasten it to the floor using three masonry screws.
Next, I use my 4-foot level to plumb up and mark where the top of the wall will meet the stairs.
I make a mark on both ends and connect them with a level.
Now I need to figure out the angle of the steps- I start by making a plumb line on the stringer; then I take my speed square and rotate it so it’s parallel with this line- It’s a 31-degree angle.
I used my table saw to make a 31-degree bevel on both sides of the top plate.
I fasten this to the bottom of the stairs using decks screws- two per stringer.
Measuring from the bottom plate to the top plate I get the lengths for my studs.
I set my miter saw to 31-degrees and make the cuts.
It’s good to check that the angle is correct before cutting all of them.
I use screws to install everything so there are no squeaks- two in the top and two in the bottom.
Finally, I put the rest of the studs in- one directly under each stringer.
Now, these stairs are super sturdy – if you like this content, be sure to like and subscribe. ‪@hausplans‬

#build #howto #carpentry #framing #stairs #wall #construction #diy #contractor


Auf dieser Seite können Sie das Online-Video Framing A Support Wall Under Stairs mit der Dauer stunde minuten sekunde in guter Qualität ansehen, das der Benutzer HAUS PLANS ®️ 27 Juni 2024 hochgeladen hat, den Link mit Freunden und Bekannten teilen, dieses Video wurde auf Youtube bereits 19,508,155 Mal angesehen und es wurde von 589 tausend den Zuschauern gefallen. Viel Spaß beim Betrachtenden Zuschauern gefallen!