Solidworks to Rhino Surface Evaluation Macro
Now and then I check Solidworks surface output in Rhino as I have much more control over the evaluation mesh density in Rhino. In my previous video I imported a surface body into Rhino to run a zebra analysis on a fillet surface that looked a bit lumpy in Solidworks, but it turned out it was just a meshing artifact. That got me thinking I would check surfaces much more in Rhino if there was a one button solution to connect the two, so I have spent a bit of time getting my head around VBA and writing macros... I had not planned to post the macro (as then any macro PROs may judge :) but decided it cannot hurt, so it is listed below. This is for Rhino 7 so it may need tweaking if you are using a different version. Also if anyone has suggestions, always keen to hear them!
If you find this video useful, please subscribe. Cheers, AJ.
The file used in the video can be downloaded here...
https://drive.google.com/file/d/1k2bX...
For more Solidworks videos, please visit my channel.
/ @andrewjacksondesignstudio
Please visit my site for more information. https://ajdesignstudio.co.nz/
#solidworks #industrialdesign
Auf dieser Seite können Sie das Online-Video Solidworks to Rhino Surface Evaluation Macro mit der Dauer stunde minuten sekunde in guter Qualität ansehen, das der Benutzer Andrew Jackson | AJ Design Studio LTD 05 Oktober 2022 hochgeladen hat, den Link mit Freunden und Bekannten teilen, dieses Video wurde auf Youtube bereits 1,675 Mal angesehen und es wurde von 38 den Zuschauern gefallen. Viel Spaß beim Betrachtenden Zuschauern gefallen!
