Solidworks to Rhino Surface Evaluation Macro

Publicado el: 05 octubre 2022
en el canal de: Andrew Jackson | AJ Design Studio LTD

1,675

Now and then I check Solidworks surface output in Rhino as I have much more control over the evaluation mesh density in Rhino. In my previous video I imported a surface body into Rhino to run a zebra analysis on a fillet surface that looked a bit lumpy in Solidworks, but it turned out it was just a meshing artifact. That got me thinking I would check surfaces much more in Rhino if there was a one button solution to connect the two, so I have spent a bit of time getting my head around VBA and writing macros... I had not planned to post the macro (as then any macro PROs may judge :) but decided it cannot hurt, so it is listed below. This is for Rhino 7 so it may need tweaking if you are using a different version. Also if anyone has suggestions, always keen to hear them!

If you find this video useful, please subscribe. Cheers, AJ.

The file used in the video can be downloaded here...
https://drive.google.com/file/d/1k2bX...

For more Solidworks videos, please visit my channel.
/ @andrewjacksondesignstudio

Please visit my site for more information. https://ajdesignstudio.co.nz/

#solidworks #industrialdesign

En esta página del sitio puede ver el video en línea Solidworks to Rhino Surface Evaluation Macro de Duración hora minuto segunda en buena calidad , que subió el usuario Andrew Jackson | AJ Design Studio LTD 05 octubre 2022, comparta el enlace con amigos y conocidos, en youtube este video ya ha sido visto 1,675 veces y le gustó 38 a los espectadores. Disfruta viendo!

33,515,265

345K