Solidworks to Rhino Surface Evaluation Macro
Now and then I check Solidworks surface output in Rhino as I have much more control over the evaluation mesh density in Rhino. In my previous video I imported a surface body into Rhino to run a zebra analysis on a fillet surface that looked a bit lumpy in Solidworks, but it turned out it was just a meshing artifact. That got me thinking I would check surfaces much more in Rhino if there was a one button solution to connect the two, so I have spent a bit of time getting my head around VBA and writing macros... I had not planned to post the macro (as then any macro PROs may judge :) but decided it cannot hurt, so it is listed below. This is for Rhino 7 so it may need tweaking if you are using a different version. Also if anyone has suggestions, always keen to hear them!
If you find this video useful, please subscribe. Cheers, AJ.
The file used in the video can be downloaded here...
https://drive.google.com/file/d/1k2bX...
For more Solidworks videos, please visit my channel.
/ @andrewjacksondesignstudio
Please visit my site for more information. https://ajdesignstudio.co.nz/
#solidworks #industrialdesign
Nesta página do site você pode assistir ao vídeo on-line Solidworks to Rhino Surface Evaluation Macro duração hora minuto segundo em boa qualidade , que foi baixado pelo usuário Andrew Jackson | AJ Design Studio LTD 05 Outubro 2022, compartilhe o link com seus amigos e conhecidos, no youtube este vídeo já foi visto 1,675 vezes e gostou 38 espectadores. Boa visualização!
